, ist aus dem raspi Projekt.
Ich einen LM 317 im TO-92 Gehäuse mit 2 * 470Ohm beschaltet und ~2,54V d...
// add the 7 Segment LED
// pin 12 is connected to the DataIn
// pin 11 is connected to the CLK
// pin 10 is connected to LOAD
// only one MAX72xx Chip
// LedControl(dataPin,clockPin,csPi
0x => https://www.silabs.com/products/development-tools/software/usb-to-uart-bridge-vcp-drivers ).
----
==== Firmware bereitstellen ====
Arbeitsverzei... are auch per Cloud Service erstellen lässt.
=== Tools für das Flaschen des Chips===
Leider ist dies... mware Repository nicht die neuste, daher nun das Tool direkt geladen
https://github.com/espressif/es
=
DS18S20
* Measures Temperatures from -55°C to +125°C (-67°F to +257°F)
* ±0.5°C Accuracy from -10°C to +85°C
* <fc #800000>9-Bit</fc> Resolution
DS18B20
* Measures Temperatures from -55°C to +125°C (-67°F to +257°F)
* ±0.5°C Accuracy from
== Alternativ - In einer eigenen Linux VM ===
tool Chain aufbauen:
Siee => https://docs.espressif.... raclelinux-developer-release-el8.x86_64
</code>
Tools installieren:
<code bash>
# Tool Chain aufsetzen
dnf group install "Development Tools"
dnf install gcc
dnf install git wget make f
chdacht und gut verständlich, das Display ist als Touch Display ausgelegt, das Gerät kann aber auch vo... Installation starten
* Ziel Verzeichnis wie D:\tools\AT82X\ auswählen
* Installation startet und ... lemented with AT826
print('-- try to get Feature Report')
for freport ... uffer)
# May be must be 1 ?? to trigger the send process of the api???
tp://www.digitalsmarties.net/|JeeLabs]]).
* USB to Serial Adapter bzw. Kabel aus der Bastelkiste
So... e Software Flash Magic installieren z.B. unter d:\tools\FlashMagic
* LPC USB Treiber mit installi... t/ds/symlink/lp2950-n.pdf|LP 2950]] ACZ3,3 in der TO-92 Bauform.
Die erste Schaltung frei nach dem [[... t! Hura!!
Terminal im Flash Magic starten (Unter tools / Terminal):
* {{ :elektronik:lpc81x:lpc81
sure in hectopascals multiplied by 1000 converted to sea level
<code lua>
alt=261-- altitude of the ... nktioniert! Hier scheint etwas mit neu/alt BME280 total schief zu laufen, dies ist eine der negativen
siehe auch => https://www.mikrocontroller.net/topic/321544 und http://www.edaboard.de/daten-anleit... meter mit GPIB => https://www.mikrocontroller.net/topic/416247
=== Details ===
* http://www.josvand